Skip directly to content

No data was found in order to be able to use the app offline. Would you like to download the data now?

Back

M-Class Model 164 cross-country vehicle, 2005 - 2011

Pictogram of drive Hybrid Diesel Pictogram of drive Hybrid Petrol

  • Oblique view of vehicle from front left
  • Oblique view of vehicle from rear right
Line drawing of vehicle with markings of safety-relevant components and rescue points.
  • Pictogram for Airbag

    Airbag

  • Pictogram for Gas generator

    Gas generator

  • Pictogram for Seat belt pretensioner

    Seat belt pretensioner

  • Pictogram for SRS control unit

    SRS control unit

  • Pictogram for Gas strut / Preloaded spring

    Gas strut / Preloaded spring

  • Pictogram for High strength zone

    High strength zone

  • Pictogram for Low-voltage battery

    Low-voltage battery

  • Pictogram for Petrol fuel tank

    Petrol fuel tank

  • Pictogram for Battery pack, High-voltage

    Battery pack, High-voltage

  • Pictogram for High voltage component

    High voltage component

  • Pictogram for High voltage device that disconnects high voltage

    High voltage device that disconnects high voltage

Note: Please see our emergency response guide for more information

1. Identification / recognition

3. Disable direct hazards / safety regulations

Deactivation of the high-voltage system

In all other cases, the high-voltage system should be deactivated as follows:

Option

High-voltage disconnect

The high-voltage disconnect device is located on the right at the rear of the high-voltage battery.

Lift load compartment floor (1) / Remove cover (2) / Push switch (3) to the right and pull off high-voltage battery

Pictogram for danger

In order to ensure that there is no longer any residual voltage in the high-voltage system, wait approx. 20 seconds after switching it off.

Pictogram for danger

The passive safety systems such as airbags and seat belt pretensioners will continue to be supplied with power by the 12-volt electrical system.

Disconnecting the 12 V battery

1. Remove the cover from the 12-volt battery.
2. Disconnect the negative cable of the 12-volt battery at the screw connection and secure it against unintentional contact.